Filter
Top Products
12
Cancelling end buzzer after washing
1. Press [START/HOLD] button and [POWER ON] button at the same time, release [POWER ON] button
and hold [START/HOLD] button at least for 3 seconds. Two times beep sound indicates the end buzzer
of washing has been cancelled.
• Repeat step 1 to activate the end buzzer. Four times beep sound indicates the end buzzer has been
activated.
• When the power cord is unplugged or a power outage occurs, the last setting of the end buzzer will be
remained.
2. Press
1. While pressing
CHILD LOCK program
This is an emergency alarming mode with a continuous buzzer sounds when child open the lid
during operation to prevent a child from drowning (condition where there is a water inside the tub)
by falling into the tub which contains water.
Close the lid to stop the buzzer. If the lid is kept open for more than 10 seconds, the machine will
force drain the water inside the tub assuming that the child had fallen into the tub but make sure
that the drain hose is laid down.
• This is different from the function that lock button operation and the lid.
7 IN THE CASE OF FORCE DRAINING.
There will be an abnormal alarm (fl ickering of lamps and buzzer).
Please check inside the tub.
7 RESET METHOD OF ABNORMAL ALARM.
Button operation cannot be used.
At fi rst, unplug the power cord from the outlet and re-plug it again after 5 seconds.
Please repeat the operation from the beginning because the process had been cancelled.
2. Press the [PROGRAM]
button for at least 5 seconds.
1. Press the [POWER ON] button.
7 SETTING METHOD
1. Press the [POWER ON] button.
2. Press the [PROGRAM] button for at least 5 seconds.
The buzzer sounds (two times for setting) and the [CHILD LOCK] indication turns on.
7 CANCELLING METHOD
Repeat the operation 1 and 2.
The buzzer sounds (4 times for cancelling) and the [CHILD LOCK] indication turns off.
[NOTE]
When you press [PROGRAM] button, it switches over, from “NORMAL” to “SPEEDY”, for example.
7 Please do not leave water inside the tub as [CHILD LOCK] mode does not function in
the following case:
• In the case of power supply off.
• In the case when forget to lay down the drain hose.
• Please close the lid immediately after press the [START/HOLD] button because when the lid is open,
there will be an abnormal alarm and force drain during water feeding.
NA-F62-70B1-ENABPS.indd 12NA-F62-70B1-ENABPS.indd 12 5/8/08 9:16:38 AM5/8/08 9:16:38 AM