Filter
Top Products
D Load the drum
^
Open the drum door.
^
Load the laundry loosely into the
drum.
See the drying programme chart for
maximum loads. Overloading can
cause unnecessary wear and tear to
the laundry and give a disappointing
drying result.
E Close the drum door.
Make sure that no garments are
caught between the drum door and
seal.
Make sure you have removed any
detergent dispensing aids, e.g.
plastic dispenser balls, before
drying. These dispensers can melt
during the drying programme and
cause damage to the machine and
the laundry.
The stopcock must be open even if
you are only using the machine for
drying.
F Start the programme
^
Press the flashing Start/Stop button.
The estimated programme duration will
appear in the display. The electronics
continually assess the residual moisture
content of the laundry and adjust the
estimated time remaining for a more
accurate reading. Becaue of this the
time displayed can alter during the
course of a programme. The time left
will count down by the minute in the
display.
The programme sequence and the
drying level reached will also be shown
in the display.
G End of the programme - unload the
drum
The anti-crease phase starts as soon as
the programme finishes.
The washer-dryer will switch off
automatically 15 minutes after the
end of the anti-crease phase. You will
need to press the K button to switch
it back on again.
^ Turn the programme selector to the
Stop position.
^ Open the drum door and remove the
laundry.
Check that all items have been
removed from the drum. Anything
left in the machine could be
damaged by overdrying when it is
next used.
Important. Always remove the
laundry before switching the machine
off. This is important to ensure that
the load size indicator works
correctly.
^
Switch the machine off.
See "After each washing or drying
programme" in "WASHING AND
DRYING" for further information.
DRYING
38