Filter
Top Products
Fitting a plinth facing.
The appliance plinth below the door
can be fitted with a plinth facing to
match your kitchen.
The height and return of the appliance
plinth cannot be altered.
A higher plinth facia can only be fitted if
the overall niche height is higher.
Plinth height Niche height
100 mm
(standard)
820 mm -
150 mm 870 mm one spacer
frame is
required
200 mm 920 mm two spacer
frames are
required
Plinth facing (60 cm long) can be
ordered from your Kitchen Dealer or
manufacturer.
Before fitting the plinth facing please
note:
Under no circumstances must
anything be stuck over the flap(s) in
the appliance plinth.
Fitting the plinth facing:
^
Stick the velcro strip provided to the
appliance plinth.
For this the following procedure is
recommended:
^
Match up the hooked side and the
looped side of the velcro strip
lengthwise.
^
Cut it into 2 or 3 sections.
^
Peel the protective backing off one
side of the lengths of velcro.
^
Position the velcro strips along the
appliance plinth, at the left and right
hand sides and in the middle and
then press firmly into place.
^ Carefully remove the remaining
protective foil from the velcro.
^ Press the plinth facing onto the
adhesive surface of the velcro strips
and press firmly into position.
Installation and connection
65