Filter
Top Products
The wash programme stops and a fault indicator light comes
on.
Problem Possible cause Remedy A
The Check drain light
flashes.
"- - -" appears in the
display.
The water outlet is
blocked.
Clean the fluff filter and the
drain pump as described in
"Problem solving guide –
Opening the lid in the event
of a blocked water outlet
and/or a power failure".
The drain hose has
been fixed too high.
The maximum drain height is
1 m.
The Check inlet light
flashes.
"- - -" appears in the
display.
The water inlet is
blocked.
Open the stopcock.
The filter in the water
inlet hose is dirty
Clean the filter.
The Check inlet and
Check drain lights are
flashing.
"- - -" appears in the
display.
The water protection
system has reacted.
Call the Service Department.
The Soak/Pre-wash or
Rinses indicator light
is flashing.
"– – –" appears in the
display.
There is a fault. Start the programme again. If
the fault indicator occurs
again, contact the Miele Ser
-
vice Dept.
A To switch off the fault message: switch the washing machine off with the
I-On/0-Off
button and turn the programme selector to
Finish
.
Problem solving guide
39