Filter
Top Products
The wash programme stops and a fault indicator light comes
on.
Fault indicator Possible cause Remedy A
The Check drain light
flashes. "– – –" appears
in the display.
The water outlet is
blocked.
Clean the drain filter and the
drain pump as described in
"Problem solving guide -
Opening the drum door in the
event of a blocked drain outlet
and/or power failure".
The drain hose has
been fixed too high.
The maximum delivery head
is1m.
The Check inlet light
flashes. "– – –" appears
in the display.
The water inlet is
blocked.
Open the stopcock.
The filter in the water
inlet hose is dirty.
Clean the filter.
The Check inlet and
Check drain lights are
flashing. "– – –" appears
in the display.
The water protection
system has reacted.
Call the Service Department.
The Soak/Pre-wash or
Rinses indicator light is
flashing. "– – –" appears
in the display.
There is a fault. Start the programme again.
If the fault indicator occurs
again, contact the Service
Department.
A To switch off the fault indicator: switch the washing machine off with the
I-On/0-Off button and turn the programme selector to d Finish.
Problem solving guide
36