Filter
Top Products
Installation
The machine must be perfectly level to
ensure safe and proper operation.
Minor differences do not, however,
have an adverse effect on operation.
The screw feet can be adjusted to
compensate for any uneveness in
the floor surface.
Important
A gap of 10 mm must be main-
tained between the bottom of ma-
chine and the floor. This gap must
not be blocked by deep pile carpet,
plinths etc., as this will prevent a suf-
ficient intake of cold air.
Installation
Take into consideration the space re-
quired by the vent duct when calculat-
ing the distance between the machine
and a wall or other appliances or furni-
ture on either side or between the ma-
chine and the wall.
It is possible to install this appliance
under a continuous worktop / in a row
of kitchen units using a special conver-
sion kit*. The machine lid is replaced
by a coverplate which must be fitted by
a suitably competent person to ensure
electrical safety.
Flat type ducting * is required if there is
not enough space for a vent duct.
When installing under a worktop with a
working height of 900/910 mm: a
spacer kit * is needed.
When built under, the programme run-
ning times may be longer.
The tumble dryer can also be com-
bined with a Miele washing machine in
a washer-dryer stack. For this purpose
the appropriate stacking kit * to match
your washing machine is required.
* These items are all available from
your Miele Dealer.
18