Filter
Top Products
What if ... Possible cause Solution
At the end of a
program
Clean filter or
Clean the lint filter
appears
The dryer reminds you to
clean the lint filter.
–
Remove and clean the lint filter.
To delete this message:
–
Confirm with "OK".
The cycle of the "Clean
filter" message can be
adjusted.
–
See "Settings - Supervisor level
- Cleaning the lint filters".
Clean out airways
The dryer does not work
at its optimum or not
efficiently.
Possible cause:
clogging by lint or
detergent residues.
–
Check all possibilities as
described under "Other faults -
The program runs too long or
stops".
To delete this message:
–
Confirm with "OK".
The exhaust duct may
be very long. This is not
a fault.
With a long exhaust duct, program
times and energy consumption
increase.
The "Clean out airways" message
cycle can be adjusted.
– See "Settings - Supervisor level
- Cleaning the airways".
Program finish
time changed
This is not a fault. While the timer was counting
down, the settings were changed
or there was a power failure.
Frequently asked questions
27