Filter
Top Products
The wash programme stops and a fault indicator light comes
on.
Problem Possible cause Remedy A
The Check drain light
flashes.
The water outlet is
blocked.
Clean the fluff filter and the
drain pump as described in
"Problem solving guide -
Opening the drum door in
the event of a blocked drain
outlet and/or power failure".
The drain hose has
been fixed too high.
The maximum delivery head
is1m.
The Check inlet light
flashes.
The water inlet is
blocked.
Open the stopcock.
The filter in the water
inlet hose is dirty.
Clean the filter.
The Check inlet and
Check drain lights are
flashing.
The water protection
system has reacted.
Call the Service Department.
The Soak/Pre-wash or
Rinses indicator light is
flashing.
There is a fault. Start the programme again.
If the fault indicators occur
again, contact the Service
Department.
A To switch off the fault indicator: switch the washing machine off with the
I-On/0-Off button and turn the programme selector to Finish.
Problem solving guide
36