Filter
Top Products
10
WASHER MAINTENANCE
Replace inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
WATER INLET HOSES
Operate your washer only when you are home. If moving, or
not using your washer for a period of time, follow these steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer, to avoid ooding due to
water pressure surge.
WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer
where it will not freeze. Because some water may stay
in hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize washer:
1. Shut off both water faucets; disconnect and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on RINSE AND SPIN cycle for about 30 seconds
to mix antifreeze and remaining water.
3. Unplug washer or disconnect power.
NON-USE AND VACATION CARE
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your garments.
To keep washer interior odor-free, follow this recommended
monthly cleaning procedure:
1. Make sure the washer is empty.
2. Using recommended AFFRESH
®
washer cleaner, add one
tablet to washer drum.
OR
If using liquid chlorine bleach, add 1 cup (250 mL) to liquid
chlorine bleach dispenser.
IMPORTANT: Do not add detergent to CLEAN WASHER
with AFFRESH™ cycle. Do not use more than recommended
amount of bleach to avoid damaging product over time.
3. Close washer lid.
4. Press POWER.
5. Select CLEAN WASHER with AFFRESH™ cycle.
6. Press START/Pause. Water will pour into washer for a
moment and pause, lid will lock, then cycle will continue.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted, press POWER and run a RINSE AND SPIN
cycle to ensure cleaner or bleach have been rinsed from
washer.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use all-purpose surface cleaner, if needed.
IMPORTANT: To avoid damaging the washer’s nish, do not
use abrasive products.
TRANSPORTING YOUR WASHER
1. Shut off both water faucets. Disconnect and drain water
inlet hoses.
2. If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
3. Disconnect drain from drain system and drain any
remaining water into a pan or bucket. Disconnect drain
hose from back of washer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside washer basket.
6. Drape power cord over edge and into washer basket.
7. Place packing tray from original shipping materials back
inside washer. If you do not have packing tray, place heavy
blankets or towels into basket opening. Close lid and place
tape over lid and down front of washer. Keep lid taped until
washer is placed in new location.
CLEANING YOUR DISPENSERS
You may nd laundry product residue leftover in your
dispensers. To remove residue, wipe with a damp cloth and
towel dry.