Filter
Top Products
20
WASHER CARE
Cleaning Your Washer
Washer Maintenance Procedure
This washer has a special cycle that uses higher water volumes, in combination with AFFRESH™
washer cleaner or liquid chlorine bleach to thoroughly clean the inside of the washer.
NOTES:
■ Read these instructions completely before beginning the cleaning process.
■ It is recommended that you allow the cleanout cycle to complete without interruptions. If
necessary, the cleanout cycle may be interrupted by pressing the Power button once or
the Pause/Cancel button twice.
IMPORTANT: If the cleanout cycle is interrupted, run a Rinse & Spin cycle to ensure that
all remaining bleach is rinsed from the washer.
Begin procedure
1. Open the washer door and remove any clothing or items from the washer.
2. Using the AFFRESH™ washer cleaner (Recommended):
Add one AFFRESH™ washer cleaner tablet to the washer drum.
If using liquid chlorine bleach:
Add 1 cup (250 mL) liquid chlorine bleach to the bleach dispenser.
NOTE: Do not add any detergent to this cleaning cycle. Use of more than 1 cup
(250 mL) of bleach will cause product damage over time.
3. Close the lid.
4. Press POWER.
5. Turn Cycle Control knob to Clean Washer cycle.
■ The Estimated Time Remaining display will show approximately 60 minutes.
6. Press START.
■ The cycle will begin and water will dispense in the washer for a moment and pause,
then the lid will lock and the cycle will continue.
■ Once the cleaning cycle has begun, allow the cycle to complete. An estimated cycle
time will appear on the display.
Always do the following to maintain washer freshness
■ Use only High Efficiency (HE) detergent when washing a clothes load.
■ Repeat the cleaning procedure monthly, using one AFFRESH™ clean washer tablet or
1 cup (250 mL) of liquid chlorine bleach.
■ If the procedure does not sufficiently improve washer freshness, evaluate your installation
and usage conditions for other causes.
Cleaning the exterior
Use a soft damp cloth or sponge to wipe up any spills. Occasionally wipe the outside of your
washer to keep it looking new. Use mild soap and water. Do not use abrasive products.
Water Inlet Hoses
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect
and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, mark the date of replacement on the label with a permanent
marker.
Vacation, Storage and Moving Care
Install and store your washer where it will not freeze. Because some water may stay in the
hoses, freezing can damage your washer. If storing or moving your washer during freezing
weather, winterize it.
Non-use or vacation care:
Operate your washer only when you are at home. If you will be on vacation or not using your
washer for an extended period of time, you should:
■ Unplug washer or disconnect power.
■ Turn off the water supply to the washer. This helps avoid unintended flooding (due to a
water pressure surge) while you are away.
To winterize washer:
1. Shut off both water faucets.
2. Disconnect and drain water inlet hoses.
3. Put 1 qt (1 L) of R.V.-type antifreeze in the basket.
4. Run washer on the Rinse & Spin setting for about 30 seconds to mix the antifreeze and
remaining water.
5. Unplug washer or disconnect power.