Filter
Top Products
15
Stopping the Washer
You can stop the wash cycle and drain the tub by pressing the Pause/Cancel button twice or
the Power button once.
Changing Cycles, Modifiers and Options
You can change Cycles, Modifiers and Options anytime before Start is pressed. Not all
Modifiers and Options are available for all cycles.
■ A short tone sounds when a change is selected.
■ Three short tones sound if an unavailable combination is selected. The last selection will
not be accepted.
Changing Cycles after pressing Start
1. Press PAUSE/CANCEL twice to cancel the cycle. The washer will drain.
2. Press POWER.
3. Select the desired wash cycle.
4. Select the desired Modifiers and Options.
5. Press START.
The washer restarts at the beginning of the new cycle.
NOTE: If you do not press Start within 5 minutes of pausing the washer, the washer
automatically shuts off.
Changing Modifiers and Options after pressing Start
You can change a Modifier or Option anytime before the selected Modifier or Option begins
by choosing the desired Modifiers and/or Options.
NOTE: An error tone will sound if your selection is unavailable.
To manually drain the washer and spin the load
1. Press PAUSE/CANCEL twice to cancel the wash cycle and drain the washer.
2. Press POWER.
3. Turn knob to select DRAIN & SPIN.
4. Press START.
When the spin is complete, the lid unlocks. Items can be removed from the washer.
Status Lights
These lights show which portion of the cycle the washer is operating. They also indicate when
you can add other garments to the wash load.
Indicator lights
An indicator light shows which Cycle, Modifiers and Options you have selected.
Estimated Time Remaining
When a wash cycle is started, the estimated time remaining for the cycle, including fills and
drains, will be displayed. The time will count down to the end of the cycle.
Cycles
Turn the knob to choose the right wash cycle for the type of fabrics you are washing. When
the knob points to a cycle, the indicator light for the cycle will glow and the indicator light for
Start will blink. If the default settings for the Modifiers and Options are acceptable, you may
press Start to begin the wash cycle.
Preset Cycle Settings
For ease of use, preset cycle settings provide the recommended fabric care settings for each
cycle.
To use the preset cycle settings:
1. Press POWER.
2. Select the cycle you want by turning the knob. The preset cycle settings will be displayed
(see following chart).
NOTE: The preset times may vary slightly depending on your model.
3. Press START. The wash cycle will begin.