Filter
Top Products
1. LEVELING 2. STABILITY
/
WITHHANDS
FOOT TO CHECKIF
LEVELAND
STABLE
Set all leveling feet at same height. A Place dryer in the location where it will
minimum of Y2'clearance between the be used. Check, by rocking dryer with
machine and the floor is recommend- hands on opposite corners, that all
ed. Adjust to match the height of your four (4) feet are infirm contact withthe
dryer, floor. If it rocks, adjust as needed.
3A. OUTSIDEWALL 3B. BASEMENTWALL 3C. FLOOREXHAUSTING
r BASEMENTWINBOWJ
WALL
_o
SIDEVIEW
OUTSIDEWALL-- '
I Attach dryer vent pipe to outside If space permits,a 4" dia.elbow point-
exhaust vent. Outside exhaust vent ed downwardthroughthefloor maybe
shouldfit overdryer vent pipe toavoid In basements,the exhaustcan be ele-
catching lint.Tape all joints with heat vated by installingelbows to raise the used If not possible,the dryer maybe
duct tape. vent hood above the ground level, tratedexhaustedlaterthroughinthis manual.thebottom as illus-
3D. INDOOREXHAUSTING 4. ELECTRICALCONNECTION INSTALLATIONWlTH
(NOT RECOMMENDED unless POWERCORD(PIGTAIL).
conditionson page 6 are met.)
POWER CORD
__ ATTACHMENT WALL
DRYER PLUG RECEPTACLE
MAINSERVICE
._, _ ENTRANCEPANEL
When exhausting indoors, use the This appliance mustbe connected to agrounded metal,permanent wiring
indoor exhaust kit and maintain a mini- system; or an equipment - grounding conductor must be run with the cir-
mum clearance of 6 inches between the
rear of the dryer and any adjacent wall. cuit conductors and connected to the equipment - grounding terminal or
Read further instructions in this manual, lead on the appliance.
Page 6.
4