LG Electronics WD-3245RHD Washer User Manual


 
25
roubleshooting Guide
Symptom Possible Cause Solution
• Water supply it not adequate in area
• Water supply taps are not completely
open.
• Water inlet hose are kinked.
• The filter of the inlet hose clogged.
• Drain hose is kinked or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance
detection and correction system. If
individual heavy articles are loaded
(bath mat, both robe, etc.,) this
system may stop spinning or even
interrupt the spin cycle altogether if
the imbalance is too great even after
several spin starts.
• If the laundry is still too wet at the end
of the cycle, add smaller articles of
laundry to balance the load and
repeat the spin cycle.
• Is the door
opened?
• If the water overfills due to the faulty
water valve, you will get
display.
is displayed if the water level
sensor malfunction.
• Overload in motor.
• Overload in motor.
• Check water supply.
Check another tap in the house.
Fully open tap.
Straighten hose.
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning
Close the door.
If is not released, call for service.
Unplug the power plug and call for
service.
Close the water tap.
Unplug the power plug.
Call for service.
T
Turn the tap on.
If is not released, unplug
power plug and call for service.
NO INLET
IMBALANCE
NO DRAIN