Filter
Top Products
20
aintenance
M
The water inlet filter
- No Inlet error message will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is a good idea to clean it from time to time.
The drain pump filter
❋
The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
CAUTION First drain it using the drain hose and then open the pump filter to remove
whatever may have stopped it up.
Be careful when draining if the water is hot.
❋
Before cleaning the washer interior, unplug the electrical power cord to avoid electrical
shock to avoid electrical shock hazards.
3
2
3
2
1
100
1. Turn off the
water tap.
2. Unscrew the
water inlet
hose.
3. Clean the
filter using a
hard bristle
brush.
4. Tighten up
the inlet
hose.
!
1.
Open the lower cover
cap
by using coin.
Turn the drain plug
to pull out the hose.
2.
Unplug the drain plug , allowing
the water to flow out. At this time
use a vessel to prevent water
flowing on to the floor. If the water
does not flow any more, turn the
pump filter
open to the left.
3. Take out any foreign material
from the pump filter
. After
cleaning, turn the pump filter
clockwise and insert the drain
plug
to the original place.
close the lower cover cap.