Filter
Top Products
Load is wrinkled Garment damage
Did you unload the washer promptly?
Unload the washer as soon as it stops.
Did you use the right cycle for the load being washed?
Use the Delicate speed setting.
Bid you overload the washer?
The wash load must be balanced and not overloaded. Loads
should move freely during washing.
Are the hot and cold water hoses reversed?
Check to be sure the hot and cold water hoses are connected •
to the right faucets. See "installation Instructions."
Load is tangled or twisted
• Did you overload the washer?
See "Starting Your Washer" for maximum load size. Loads
should move freely during washing.
• Check the following:
Were sharp items removed from pockets before washing?
Empty pockets, zip zippers, snap or hook fasteners before
washing.
Were strings and sashes tied to prevent tangling?
Were items damaged before washing?
Mend rips and broken threads in seams before washing.
Did you overload the washer?
See "Loading" for maximum load size.
Bid you properly add chlorine bleach?
Do not pour chlorine bleach directly on load. Use your liquid
chlorine bleach dispenser. Wipe up bleach spills. Undiluted
bleach will damage fabrics. Do not place load items on top of
the bleach dispenser when loading and unloading the washer.
• Bid you follow the manufacturer's care label instructions?
Gray whites, dingy colors Wash/Rinse temperature is not what I selected
• Bid you properly sort the load?
Dye transfer can occur when mixing whites and colors in a
load. Sort dark fabrics from whites and lights.
• Are the hot and cold water inlet hoses reversed?
As washing progresses, the wash temperature will decrease
slightly for hot and warm washes. This is normal.
Was the wash temperature too low?
Use hot or warm washes if safe for the load. Make sure your
hot water system is adequate to provide a hot water wash.
To reduce wrinkling, the warm rinse is regulated to be cooler
than the warm wash.
Did you use enough detergent, or do you have hard
water?.
Use more detergent for washing heavy soils in cold or hard
water. Water temperature should be at least 70°F (21°C) for
soap to dissolve and work properly.
Did not get CATALYS'P Cleaning Action
• Did you set the Cycle Selector Control (Timer) knob on
the blue oval labeled CATALYST_?
The blue oval labeled CATALYST-_must be selected on the
Cycle Selector Control (Timer) knob for it to be included in a
wash cycle.
CATALYST " Cleaning Action is available only in the Ultra
Clean and Whitest Whites cycles.
18