Filter
Top Products
of connectors are available from good
hardware stores and plumbers merchants to
suit most domestic plumbing. Any alteration
to your existing plumbing must be carried
out by a competent person, or qualified
plumber.
Water inlet
Warning! This appliance must
be connected to a cold water
supply.
The inlet hose is screwed to the back of the
appliance.
1. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks. Always use the hose
supplied with the appliance.
Important! Do not place the inlet
hose downwards. Angle the hose to
the left or right depending on the
position of your water tap as
indicated in the picture.
35°
45°
2. Connect the water inlet hose supplied
with the machine to a tap with a 3/4"
thread. Installation should comply with
local water authority and building
regulations’ requirements.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
Warning! Installation should
comply with local water
authority and building
regulations’ requirements.
The appliance must be
connected to a cold water
supply.
A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe
operation of the appliance.
If you cannot make the cold water
connection direct from the rising
mains, you may be able to operate
the appliance from your cold water
storage system.
There should be a minimum vertical
distance of 5.02 m (16.5 ft) between
the appliance’s inlet and the bottom
of the water storage tank.
Water drainage
This appliance is designed to be permanently
plumbed into your home's drainage system
using one of the following methods.
30