Filter
Top Products
The washing machine has stopped
with water in the tub, at the end of
the «Soak» programme or if the «Rinse
hold» option has been set: this is indicated
by a flashing zero. The «Door lock» pilot
light is still on. The door cannot be
opened.
The washing machine has
completed the programme: this is
indicated by a flashing zero. The «Door
lock» pilot light has gone off. It is now
possible to open the door.
•
Delay start, a time value indicated in
hours and selected by the relevant button.
The delay time (20 hours max) is
displayed for a few seconds, then the
duration of the selected programme
reappears. After you have pressed the
button 8, the countdown is updated every
hour, and, for the last hour, every minute.
•
An incorrect option selection has
been made: this is indicated by the
message Err for a few seconds when an
option incompatible with the current
programme is selected.
•
An alarm code indicates a fault with the
machine (see the relevant chapter).
First use
• Ensure that the electrical and
water connections comply with
the installation instructions.
• Remove the polystyrene block and
any material from the drum.
• Pour 2 litres of water into the main
wash compartment
of the
detergent drawer in order to
activate the ECO valve. Then run
a cotton cycle at the highest
temperature without any laundry
in the machine, to remove any
manufacturing residue from the
drum and tub. Pour 1/2 a measure
of detergent into the main wash
compartment and start the
machine.
11