Filter
Top Products
Before you make any change, you must
PAUSE the appliance by pressing the button
5 .
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to Off and then to the new
programme position. Start the new
programme by pressing the button 5 again.
The washing water in the tub will be not
emptied out.
Interrupting a
programme
Press the button 5 to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to Off position to cancel
a programme which is running. Now you can
select a new programme.
Opening the door
After the programme has started the door is
locked. If, for any reason, you need to open
it, set firstly the machine to PAUSE by pressing
the button 5 . After a few minutes the "Door
lock" light goes off and the door can be
opened.
If the door remains locked, this means that the
machine is already heating or that the water
level is too high. In any case, do not try to force
the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to Off position. After
a few minutes the door can be opened (pay
attention to the water level and
temperature!) .
After closing the door, it is necessary to select
the programme and options again and to
press button 5 .
At the end of the
programme
The machine stops automatically. The pilot
light of button 5 goes off and after a few
minutes the Door lock pilot light goes off.
The light End illuminates. The door can be
opened.
If a programme or an option that ends with
water left in the tub has been selected, the
light Door lock illuminates and the door
remains locked to indicate that the water must
be emptied out before opening the door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to Off .
2. Select the draining or spinning
programme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4.
Press button 5 .
At the end of the programme, the door can
be now opened. Turn the programme
selector dial to Off to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If you
do not intend to carry out another wash, close
the water tap. Leave the door open to
prevent the formation of mildew and
unpleasant smells.
If your laundry is not removed during 10
minutes after the programme is finished the
energy saving system is enabled. All options
and cycle status pilot lights are turned off, only
the button 5 pilot light is blinking to indicate
that the appliance has to be switched off. By
pressing any button the appliance will come
out from the energy saving status and you
12