Filter
Top Products
The drying cycles are automatically
followed by an anti-crease phase
which lasts around 30 minutes. The
drum rotates at intervals during this
phase. This keeps the laundry loose
and free of creases. The laundry can
be removed at any time during the
anti-crease phase. (The laundry
should be taken out towards the end
of the anti-crease phase at the latest
to prevent creases from forming.) If
Anti-crease function has been
selected, the anti-crease phase is
lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best
to use a damp hand for this purpose.
(See “Maintenance and cleaning”
chapter.)
3. Remove laundry.
4. Turn the programme selector to Off.
Important! After each drying cycle:
- Clean the micro-fine filter and fine
filter
- Drain the condensed water container
(See chapter “Maintenance and
cleaning ”.)
5. Close the door.
Maintenance and cleaning
Cleaning fluff filter
The filters collect all the fluff which
accumulates during drying. To ensure that
the dryer works perfectly, the fluff filters
(micro-fine filter and fine strainer) must be
cleaned after every drying cycle.
The warning lamp Filter lights to remind you
of this operation at the end of each cycle.
Caution! Never operate the dryer
without fluff filters or with damaged
or blocked fluff filters.
1. Open loading door
2. Use a damp hand to clean the micro-
fine filter, which is built into the lower
part of the loading aperture.
3. After a period of time, a gleam due to
detergent residue on laundry forms on
the filters. When this occurs, clean the
filters with warm water using a brush.
Remove the filter from the door pulling
it out. (It can be positioned with the
locating spur facing to the left or to the
right).
After cleaning do not forget to put it
back.
14