Filter
Top Products
Adjusting the level of
conductivity
Water contains, a variable quantity of
limestone and mineral salts of which
quantities vary according to geographical
locations thus varying its conductivity
values.
Relevant variations of the conductivity of
the water compared to those prefixed by
the factory could slightly influence the
residual humidity of the laundry at the
end of the cycle. Your dryer allows you to
regulate the sensitivity of the drying
sensor based on conductivity values of the
water.
In order to establish the conductivity of
the water in your area please contact
your water board.
1. Turn the programme selector to any
programme.
2. Press simultaneously the Anti-crease
and Start/Pause buttons and hold down
for approx. 5 seconds.
3. Press the Start/Pause button until you
set desired level:
low conductivity
<300 µS/cm
medium conductivity
300-600 µS/cm
high conductivity
>600 µS/cm
4. To memorize setting press simultaneously
the Anti-crease and Start/Pause
buttons or turn knob to Off position
22