Filter
Top Products
27
• Pull out the emergency emptying cap from the filter
cover, using a pliers.
• When no more water comes out, unscrew the
pump cover, using a pliers, and remove the filter.
Always keep a rag nearby to dry up spillage of
water when removing the cover.
• Remove any objects from the pump impeller by
rotating it.
• Replace the emergency emptying cap into the filter
cover and fix it firmly.
• Close the pump door.
Warning
When the appliance is in use and depending on the
programme selected there can be hot water in the
pump. Never remove the pump cover during a wash
cycle, always wait until the appliance has finished the
cycle, and is empty. When replacing the cover, ensure it
is securely retightened so as to stop leaks and young
children being able to remove it.
Cleaning the water inlet filter
If your water is very hard or contains traces of lime
deposit, the water inlet filter may become clogged.
It is therefore a good idea to clean it from time to time.
Turn off the water tap. Unscrew the water inlet hose.
Clean the filter using a hard bristle brush.
Refit the inlet hose. Clean carefully under a fast running
tap.
The dangers of freezing
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
●
Turn off the water tap.
●
Unscrew the inlet hose.
●
Place a bowl with a small edge close to the pump to
collect any spillage from the emergency emptying
cap.
Place the end of the inlet hose in a bowl placed on
the floor and let water drain out.
●
Screw the water inlet hose back on and reposition
the emergency emptying cap on again into the filter
cover.
●
When you intend to start the machine up again,
make sure that the room temperature is above 0°C.
P1090
132963590.qxd 27/05/2008 10.45 Pagina 27