John Lewis 1609 Washer/Dryer User Manual


 
20
6. Turn the programme selector dial to Off to switch
the machine off and remove the laundry.
Note:
The programme time will automatically increase by up
to 2 minutes, this is quite normal.
AUTODRYING
For NON-STOP programmes, the recommended load
size to wash and dry is 3,5 kg for cotton and 2 kg for
synthetics.
Note! Only with the timed drying, it is possible
also to dry up to 4 kg of cotton items (see the
drying programmes).
Do not use a dosing device/ball when carrying out a
washing & drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the selector dial
to the wash programme/fabric and temperature in
the Cotton or Synthetics section.
4. Select the drying time or dryness degree.
5. Select the required options by pressing the relevant
buttons. If possible, do not select a spin speed
lower than that proposed by the appliance to avoid
too long a drying time therefore saving energy.
The reduction of the spin speed is only possible
after selecting drying. The lowest values you can
select is 1200 r.p.m. for Cottons and 800 r.p.m. for
Synthetics with Timed Drying.
6. Start the programme by pressing the Start/Pause
button.
7. At the end of the programme, the buzzer sounds.
A flashing zero
«0» appears on the display. At this
point of the programme, starts an anti-crease phase
which lasts about 10 minutes. During this time the
door is locked and the display keeps showing the
flashing zero.
(If you wish to open the door before or during the
anti-crease phase, please follow the instructions given
in the previous chapter).
9. Turn the programme selector dial to Off to switch
the machine off and remove the laundry.
DRYING ONLY
The recommended load to dry in your washer-dryer is
3.5 kg for cotton and 2 kg for synthetics.
Note! Only with the timed drying, it is possible
also to dry up to 4 kg of cotton items (see the
drying programmes).
The water tap must be open and the drain hose must
be positioned in the sink or connected to the drain
pipe.
1. Load the laundry.
2. Turn the programme selector dial to the «Drying»
programme in the Cottons or Synthetics section.
3. If you wish to carry out the electronic drying, press
Automatic dry button until the light of the
desired dryness degree illuminates.
If you want a timed drying, press the “Time dry
button until the time you want appears on the display
(see page 14).
4. Press the Start/Pause button to start the
programme.
5. At the end of the programme, the buzzer
sounds. A flashing zero
«0» will appear on the
display. At this point, begins an «anti-crease
phase», which lasts about 10 minutes. The door
can be opened only at the end of this phase.
Attention!
If you wish to open the door before the anti-
crease phase or to interrupt it, press any key or
turn the programme selector dial to any
programme position (except Off), the door can
be immediately opened.
0.60
Time dry
Automatic dry
Iron dry
Cupboard dry
Extra dry
Drying
132963590.qxd 27/05/2008 10.45 Pagina 20