John Lewis 1609 Washer/Dryer User Manual


 
13
4 “Automatic Dry” button
This button allows you to choose the required degree
of drying for cottons and synthetics:
- Extra dry (only for cottons)
- Cupboard dry (cottons and synthetics)
- Iron dry (only for cottons)
The drying time is automatically adjusted by the
machine: the laundry will be dried to the selected
degree of dryness.
5 “Time dry” button
If you wish to carry out a timed programme instead of
an electronic programme push this button until the
drying time you want appears in the display according
to the fabrics (cotton or synthetics) you have to dry.
For Cottons you can select a drying time from 10
minutes to 200 minutes .
For Synthetics you can select a drying time from 10
minutes to 130 minutes.
Options
Depending on the programme, different functions can
be combined. These must be selected after choosing
the desired programme and before pressing the
Start/Pause” button.
When these buttons are pressed, the corresponding
pilot lights illuminate. When they are pressed again, the
pilot lights go out.
If an incorrect option is selected, the red pilot light of
the Start/Pause button flashes for a few seconds and
the message Err is displayed.
6 “Prewash” button
Select this option if you wish your laundry to be
prewashed at 30°C max. before the main wash (not
available for Wool, 45 Minute wash” and “14
Minute wash”).
The prewash cycle ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics, whereas
in the programme for delicate fabrics the water is only
drained. This option can be selected for heavily soiled
laundry.
7 “Extra rinse” button
This option can be selected with all programmes,
except Wool and “14 Minute wash”. The machine
adds 2 rinses for cotton and 1 rinse for synthetics and
delicates.
This option is recommended for people who are
allergic to detergents, and areas where the water is
very soft.
8 “Start/Pause” button
This button has two functions:
Start: after you have selected the desired programme
and options, press this button to start the washer-
dryer. The green light of the button will stop flashing
and remain lit.
If you have selected a delay time, the countdown will
begin and will be shown on the display.
Pause: when you press this button again, the
programme in progress is interrupted. The light of the
button will start flashing. To restart the programme
from the point at which it was interrupted, press the
button again.
Important!
You must set the washer-dryer to Pause before you
make any change in the programme in progress.
9 Door lock light
After you have started the programme, the Door lock
light illuminates to indicate that the machine starts
working and the door is locked.
This light is also on during the countdown of the delay
start.
This light indicates if the door can be opened:
light on: the door cannot be opened.
The appliance is operating or there is water left in
the tub. Attention! If the door is locked do not
try to open or force it!
light off: the door can be opened.
The washing programme has finished.
10 “Delay start” button
This button enables you to delay the starting of the
programme for 30 min - 60 min - 90 min, 2 hours and
then by 1 hour increments up to a maximum of 20 hours.
The delay you have selected is shown on the display for
about a few seconds; afterwards, the duration of the
programme reappears.
You must select this option after you have set the
programme and before you press the “Start/Pause
button.
132963590.qxd 27/05/2008 10.45 Pagina 13