Filter
Top Products
AC-Series Operator’s Manual-E/F 19
Preparing the Washer
CONNECT HOSES AND PRIME PUMP
IMPORTANT: Be sure that inlet water screen (A) is clean and in
place before connecting water supply hose to
AC-2000GH, AC-2400GH, AC-2600GH,
AC-2700GH, AC-3300GH, AC-2400GS,
AC-2700GS and AC-3000GS washers. The
water pump and valves could be damaged
from contaminants.
IMPORTANT: If washer is to be connected to a well water
system, use 19-0206 water inlet lter (A). This
will increase sand ltering capability and
avoid damage to the pump.
NOTE: Filling supply hose with water before attaching to pump
will greatly reduce priming time.
1. Prime water supply hose. Shut off water.
2. Connect water supply hose (B) to washer inlet. Be sure
water supply and hose meet specications. Do not turn
water on at this time.
CAUTION: Check pressure rating printed on
the hose. Use proper hoses. Use ONLY hose
#851-0338, working pressure of 4000 PSI with the
AC-3300GH and AC-3500GH pressure washers.
Hose #851-0007, with working pressure of
3000 PSI can safely be used on AC-2000GH,
AC-2400GH, AC-2400GS, AC-2500GH, AC-2600GH,
AC-2700GH, AC-2700GS and AC-3000GS.
3. Connect high pressure hose (C) to washer outlet. Give
hose a slight tug to be sure hose is connected.
4. Open water supply. Squeeze trigger on gun. Allow water to
run (without engine running) until water runs out of pressure
hose. Start engine and cycle trigger on gun until “crackling”
sound (air in lines) stops. Turn off water supply.
PIC77•102299R1
PIC78•102299R1
PIC80-A•102299R1
AC-2000GH / AC-2400GH
AC-2600GH / AC-2400GS
AC-2700GH / AC-2700GS / AC-3000GS / AC-3500GH AC-2500GH
A
B
C
PIC79•102299R1
B
C
C
B
AC-2000GH / AC-2400GH
AC-2600GH / AC-2400GS