Filter
Top Products
6 John Deere Operator's Manual
RISK OF BURNS
Serious injury may occur from
touching the heat exchanger. This
area can remain hot for some
time after the pressure washer is
shutdown.
Serious injury may occur from a
pressure washer malfunction or
exploding accessories if incorrect
system components, attachments
or accessories are used.
Serious injury or death may occur
if attempting to start the pressure
washer when the pumping system
is frozen.
Never make adjustments to the factory set
pressures.
Never exceed manufacturers maximum
allowable pressure rating of attachments.
Do not allow any hoses to make contact with heat
exchanger to prevent the possibility of bursting.
Avoid dragging the hoses over abrasive surfaces
such as cement.
Use only manufacturer recommended repair
parts for your pressure washer.
In freezing temperatures, the unit must always
be warm enough to ensure there is no ice
formation in the pump. Do not start the pressure
washer if it has been transported in an open or
underheated vehicle without first allowing the
pump to thaw.
RISK OF BURSTING
Never make adjustments to the unit while it
is connected to the power source.
Do not operate the unit without all protective
covers in place.
Follow the maintenance instructions specified
in the manual.
Never allow any part of your body to contact
the heat exchanger.
Do not leave unit unattended after shutdown
until it is completely cooled down as described
in the "SHUTDOWN" procedures listed on page
20 of this manual.
Serious injury or death could
occur from high pressure spray
penetrating the skin.
Keep clear of nozzle and spray! Never put
your hand, fingers or body directly over the
spray nozzle.
Do not direct discharge stream at persons or
self.
This product is to be used only by trained
operators.
Always keep operating area clear of all
persons.
Close supervision is necessary when used near
children. DO NOT allow children to operate
this unit!
SEEK EMERGENCY MEDICAL CARE if the
spray appears to have penetrated the skin!
DO NOT TREAT AS A SIMPLE CUT!!
High pressure hoses and fuel lines should be
inspected daily for signs of wear. If evidence
of failure exists, promptly replace all suspect
hoses and fuel lines to prevent curely locked
when not in use.
Before removing the spray nozzle or servicing
the unit, ALWAYS shut off the unit and trigger
the gun to release trapped pressure. (Even
after you shut off the unit, there is high pressure
water left in the pump, hose and gun until you
release it by triggering the gun.)
RISK OF INJECTION
OR
SEVERE CUTTING INJURY
IMPORTANT SAFETY INSTRUCTIONS
READ ALL SAFETY INSTRUCTIONS BEFORE USING PRESSURE WASHER
POTENTIAL CONSEQUENCE PREVENTIONHAZARD
Serious injury may occur to the
operator from moving parts on
the pressure washer.
RISK FROM MOVING PARTS