Filter
Top Products
John Deere Operator's Manual 13
BURNER FUEL TANK:
1. Review "Risk of Explosion or Fire" pg. 5, before fueling.
2. Locate the Safety Decals on your unit and heed their warnings.
3. Fill the burner fuel tank with good quality, clean No. 1 or No. 2 fuel oil/
diesel or kerosene. Do not use gasoline!
WARNING
RISK OF EXPLOSION OR FIRE!
ALWAYS STORE FUEL AWAY
FROM THE WASHER WHILE THE
UNIT IS RUNNING OR HOT.
DANGER
RISK OF FIRE!
-DO NOT SMOKE WHILE
FUELING!
-DO NOT FILL THE FUEL TANK
WHILE UNIT IS RUNNING OR
HOT. ALLOW UNIT TO COOL
FOR TWO MINUTES BEFORE
RE-FUELING.
-DO NOT FILL FUEL TANK TO
POINT OF OVERFLOWING.
ALLOW APPROXIMATELY 1/4"
OF TANK SPACE FOR FUEL
EXPANSION.
POWER CORD CONNECTION CONT'D.:
5. b. SINGLE PHASE: If this pressure washer is not provided
with a GFCI, this pressure washer should only be connected
to a receptacle that is protected by a Ground Fault Circuit
Interrupter (GFCI) to comply with the National Electric Code
(NFPA 70) and to provide additional protection from the risk of
electric shock.
c. THREE PHASE: These pressure washers are not provided with
GFCI protection.
6. EXTENSION CORDS: Manufacturer DOES NOT RECOMMEND
THE USE OF EXTENSION CORDS! If use of an extension cord is
unavoidable, it must be plugged into a GFCI found in circuit boxes or
protected receptacles. When using an extension cord, consult a qualified
electrician to determine the proper wire gauge needed for the length of
the extension cord.
SINGLE PHASE: Use only 3-wire extension cords that have 3-prong
grounding-type plugs and 3-pole cord connectors that accept the
plug from the product.
THREE PHASE: Use only 4 wire extension cords that have 4-prong
grounding type plugs and 4-pole cord connectors that accept the
plug from the product.
Use only extension cords that are intended for outdoor use. These
extension cords are identified by a marking "Acceptable for use with
outdoor appliances; store indoors while not in use." Use only extension
cords having an electrical rating not less than the rating of the product.
Do not use damaged extension cords. Examine extension cord before
using and replace if damaged. Do not abuse extension cord and do not
yank on any cord to disconnect. Keep cord away from heat and sharp
edges. Always connect and disconnect the extension cord from the
receptacle before connecting and disconnecting the product from the
extension cord.
7. Ensure the area between the pressure washer cord and outlet is kept
dry.
8. Insert the male plug into a grounded AC outlet. DO NOT use an adapter
OR remove the grounding plug!!
WARNING
RISK OF ELECTROCUTION!
TO REDUCE THE RISK OF
ELECTROCUTION, KEEP ALL
CONNECTIONS DRY AND OFF
THE GROUND. DO NOT TOUCH
PLUG WITH WET HANDS.
INSTALLATION & PREPARATION INSTRUCTIONS