Filter
Top Products
7.Adjust the feet...
Once the machine is in place
10
6. Move the machine into position...
Your machine is heavy so care must be taken when moving
it. To help you we have fitted wheels to the bottom rear of
the machine.
●
When moving the machine, take care not to kink or
damage the hoses at the back of machine.
●
Please take care not to damage any floor coverings
when moving the machine.
WARNING:
●
Do not drag
or lift the
machine by
it’s door.
INSTALLING
YOUR MACHINE
Your machine may become noisy or move
about if it is not level.
If necessary, to level the machine adjust
the two front feet, as follows:
1 Remove the yellow labels from the
feet.
2 Turn both the locking disc and
foot together clockwise until the
machine is standing firm and does
not rock. To check this use a spirit
level.
3 Turn only the locking disc anti-
clockwise until it is in contact with
the base of the machine.
4 Switch the machine on at plug
socket.
Locking disc
Foot
Now that you have successfully installed your new machine, we advise
that you run it through a 95˚ White Cotton programme without any
laundry and without any detergent in it.
This will check your installation, connections and drainage, and will
thoroughly clean the interior before you carry out an actual wash
programme on your laundry.
NOTE: This will take approximately 2 hours to complete.
Continue reading this book to get to know the various features of the
machine.
ULTIMA BOOK 1666200010-02 04/07/2001 4:00 pm Page 10