Filter
Top Products
Step 4. Turn the filter anti-clockwise until it stops in the vertical position.
Remove the filter and clean.
Step 5. Replace the filter and turn in a clockwise direction until locked in position.
Replace the stopper in the hose and close the filter cover.
We recommend that the filter be cleaned frequently, at least once a month.
Maintenance wash
Using small quantities of detergent and low temperature wash programmes can cause
the gradual build up of grease, dirt and scale. Over time these deposits can damage
your laundry and your machine. They can also cause your machine to smell. We
recommend that you carry out a maintenance wash a couple of times per year to keep
your machine and pipe work clean and free of these deposits. Simply run the Cottons
90°C programme without a load and with the normal quantity of detergent.
37
Care and Maintenance
The washing machine needs very little maintenance, but regular attention to a few small
details will ensure the continued performance of your washing machine.
Do not use abrasive cleaners, scouring pads, solvent-based cleaners or polishes; wiping
the outside of the machine with a damp cloth will suffice.
Cleaning the soap dispenser
It is advisable to clean the compartments occasionally to remove detergents and
additives. To do this you need to do the following:
Step 1. Pull the drawer out firmly from the machine, but without forcing it.
Step 2. Clean the compartments and the siphon cover under warm running water.
Step 3. Clean the outlet of the soap dispenser to remove any residue of soap powder.
Step 4. Replace the drawer.
Cleaning the door glass
Regularly clean the door glass with a damp cloth. A build up of soiling and residues from
the water may result in water leaking from the door.
Do not use abrasive cleaners as they can scratch the surface.
Cleaning the filter
The washing machine is fitted with a special
filter to prevent items such as coins, buttons,
etc. blocking the discharge hose. These may be
retrieved by:
Step 1. Opening the filter cover.
Step 2. Pull out the corrugated hose (only
available on certain models), remove the
stopper and drain the water into a container.
Step 3. Before removing the filter, place an
absorbent towel below the filter cap to collect
the small amount of water that is likely to be
inside the pump.
36