Filter
Top Products
Turning the machine On
Turn the machine ON by selecting a programme using the
programme selector. This status will be indicated by the STOP
indicator light flashing, this light will continue to flash until
the machine has started or the machine is returned to the OFF
position.
Start Pause
Start
After selecting the programme and the required options (see the
Wash and Dry Options section of this manual) press the Start
Pause button once to start the cycle. The STOP light will stop
flashing and START light will illuminate and there will be a short
time delay to the start of the programme while the machine sets
the wash parameters for the selected programme and options. If
the duration of the programme you have selected is shorter than
60 minutes, then the time remaining indicator will illuminate
accordingly. The door lock indicator light will also illuminate a
few seconds after pressing the Start Pause button.
Pause
The programme may be paused at any time during the wash
cycle by holding down the Start Pause button for about two
seconds. When the machine is in the paused mode, the time
remaining for the programme in the COUNTDOWN indicator
and option buttons will flash. The door lock indicator light will
remain illuminated for approximately 2 minutes. The door can
be opened when this indicator goes out. To restart the
programme, press the Start Pause button once again.
16
The Control Panel
COUNTDOWN Display
Start
Pause
OPTIONS
BUTTONS
TEMPERATURE
SELECTOR
DRYING TIME
SELECTOR
PROGRAMME
SELECTOR
The programme
selector must be return
to the OFF position to
reset the controls
between each wash
cycle.
To start another wash
cycle the programme
selector must be
returned to OFF once
again before the next
programme can be
selected and started.
40004724.qxd 26/10/2006 12:13 Page 16