Filter
Top Products
55
The power supply switch won't
work right away when transferred
from switched-off to switched on.
The indicating LED won't light
right away when the power supply
switch is switched on.
Three modes LED light after the
power supply switch is switched off.
4
It buzzes after the power supply
switch is switched off.
The lid can't be opened even when
the PAUSE button is pressed
during the dehydration.
Odor of msulating varnish smells
in the beginning of use.
It smells at the time of spinning.
Water comes out from the water
drainage hose during first time usage.
Pulsator rotates but does not display
the washings load and water quantity
after pressing the
"
START
"
button.
No reaction after starting.
There are detergent residue remained
on the detergent dispenser.
•
The power supply switch doesn't work from the cutoff of the switch
to the extinguishment of the mode LED. If the power supply is to be
switched on again, please press the switch after the LED extinguish.
•
The washing machine sound "Hoola, hoola" after the power supply is
switched on. About 1 second later, the LED light. (since the software
switch is used, the microcomputer need time for internal treatment.)
1
• When switching off the power supply with the drainage valve
opened, the drainage valve is closed, and the mode LED light.
• The operation stops after the power supply is switched off during
the dehydration, and it buzzes. That's the sound generated during
switching of the modes by clutch.
• After the power supply is cut off, the spinning basket stops
completely, and the lid lock will be unlocked.
• This is the odor of the insulating varnish of the motor in the
beginning of use. The odor exists only at the early stage, and will
dissappear about 1 week after put into application.
1
• Adverse drainage condition or excessive foams (due to excessive
detergent) may cause too much dehydration load and make the
smell even more intensive.
• Water from tests conducted by the manufacturer remains in the
drainage hose.
• This is because the sensor can not successful detect due to the
foreign interference. At that time, the power supply can be cut off
and the washing machine is to be restarted.
•
This is because the washing machine is waiting for detergent or is switching the clutch.
•
When the body is excessive oblique, the detergent may remain on the
dispenser. Please check the obliquity of the body.
About
the
power
switch
About
the flavor
Others
Case Cause
About the
washing
machine
cover lock