Filter
Top Products
8
PROBLEM
Iron won’t heat.
Water is leaking
out of the iron.
Iron won’t steam.
Iron leaves spots
on clothing.
Wrinkles not
removed.
Fabric/clothing
scorched.
Twisted cord.
Retractable cord
will not unwind.
All LCD graphics
displayed and
blinking.
Things TO CHECK
• Is the iron plugged in and the outlet working?
Check the outlet by plugging in a lamp.
• Is the Temperature Selector turned to a fabric setting?
• If auto shutoff model, is the indicator box around OFF
in the Selected Fabric Indicator blinking? If so, press
Temperature Selector/Reset Button.
• The iron will shut off if the Temperature Selector is
pressed for 3 seconds.
• Do not overfill the water tank.
• If steam ironing, is Steam ON/OFF Lever in a steam
position, Fabric Setting Indicator in the steam range,
and did the iron have enough time to preheat?
• If dry ironing, make sure the Steam ON/OFF Lever is in
the DRY IRON position.
• Check the water level.
• Has the iron had enough time to preheat?
• Is Steam ON/OFF Lever in the STEAM position?
NOTE: Anti-drip feature will not allow steam when iron
is at a temperature that would result in water leaking
from the soleplate.
• ALWAYS empty the water tank of the iron after
using. Water left in the tank may discolor clothing
and soleplate.
• Check Temperature Selector is set to correct fabric.
• Check Temperature Selector and set to lower setting.
Allow iron to cool down 5 minutes before continuing.
• If the iron cord should become twisted, turn iron OFF,
turn Selector to OFF and unplug iron. Let cool. Empty
water from iron. Hold iron cord in the middle of entire
length. Let plug and iron dangle freely until cord uncoils.
This will extend the life of your iron cord.
• Rewind a small amount of cord then fully depress the
Cord Release Button and pull the cord to desired length.
• If each fabric setting in the display is surrounded by a
rectangle and the display is blinking unplug the iron then
plug it back in. This should reset the display. If not, call
Customer Service.
Troubleshooting
840159500 Ev02.qxd 4/2/07 2:28 PM Page 8