Filter
Top Products
5
Usage the drain hose
The washing machine away from wall should be overrun 20mm. The largest allowable slope of the
shank base of the machine is 1 .The slanting or rough ground will result in unstable running or
stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
Adjust the Installation position
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
2 . After adjustment, fasten the nut.
Fasten
Loosen
High
Low
the adjustable nut
the adjustable feet
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than 10cm,
or the drainage will not be smooth, and cost such long
time that the machine may stop at mid way.
2.Do not step on or press the drain hose.
4.If extra drain hose is needed, please make separate
purchase. The inner diameter of the extra hose shall
not less than 30mm, and the length shall not exceed
1.5m.
5.If the extra hose is too long,cut it either at
A or at B point.
A
B
<10cm
A
> 30mm
<1.5m
3. If the drain hose is too long, cut it at mid point. To make
smooth drainage, cut the front end of the hose slantingly.