Filter
Top Products
The filter screen of the water inlet valve is likely to be
blocked by foreign materials and influence the water
inlet.
Please clean it with brush every two months.
8 Disposal after washing
The lint filter must be used during washing.
It must be cleaned in time after each using
The installing and dismantling method of lint
filter as follows:
Press down elastic trip at upper end of lint filter to
make the claw of elastic trip relieving from the filter
cover and pull lint filter outward. Insert lower end of
lint filter into the filter cover and push upper end into
filter cover and secure to fit on lint filter.
1.The method of dismantle: Push it up aslant and gently.
2.The method of install : install it upwards and aslant and
push it in .
Dismantle
Install
If the cabinet is dirty, wipe it with wet cloth
Do not flush it directly with water.
Wipe it with neutral detergent.
Do not wipe it with thinner, petrol, alcohol etc.
1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).
Th
inner
Petrol
Alcohol
3.Be sure to pull off the power plug before maintenance.
2.Do not store water in the washing machine for a long period. Drain the water completely after each using.
5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time
(about 1 hour), then close the top lid.
4.Hang up the power cord and drain hose.
Please first pull off the power plug from the receptacle before cleaning.
After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence
your using the machine.
If the tap water quality is bad, it can generate scale attached onto the water injection box and filling entrance
of outer tub cover. When using, please scour off the scale with wiping rags dipping with an amount of
detergent or abstergent to prevent the clothes from contamination.
The detergent box should be dismantled and washed
by water.
After washing, dismantle the lint filter and take
down back cover of filter to clean off the lint.
Install and dismantle the lint filter
Install
Dismantle
Filter cover
Lint filter
Lint filter cover
Note: after installation check whether the edges
on both sides of filter is in flush with the filter cover
or the filter falls out by shaking slightly to avoid the
fallout due to filter not installed in place.
Install and dismantle the lint
filter cover
Lint filter
Dismantle
Install
15