Haier SIG100-97 Washer User Manual


 
16
Trouble shooting answer to question
Phenomena
(If there's breakdown, please pull off the power plug before checking) The following
phenomena are not breakdowns sometimes. Please confirm again before sending it to
repair. If there are real breakdowns, please come to the special maintenance department
or after-sale service department of our company. Do not repair it by yourself.
Normal phenomena
Causes (explanations)
Intermittent spin after spin starts
Adjust balance to avoid clothes offset
Spin is selected, yet the machine doesn't spin
The program sets a drain time, spin starts
after a time.
While water filling in wash and rinse, the
pulsator pauses rotation
To prevent splash during water filling.
Small amount of water flows out upon the
washing machine is initially used
This is residual water during factory perfor
mance test.
The machine stops when top cover is opened
during running.
This is a normal fact. Due to the drum rotation,
an open cover alarm function is provided for safety.
After the "reserve" is started,
it rings and the digital tube
displays "E0"
The water faucet leaks.
There's abnormal sound
inside the machine.
The machine does not act.
(the indicators are off.)
It does not do water inlet or
the speed is slow (the water
level is not reached after 15
minutes). The digital tube
displays "E4" and it rings.
The draining does not work,
or the speed of draining is
too slow. The digital tube
displays "E1" and it rings.
It stops running during wash,
rinse or spin. The digital tube
displays "E2" and it rings.
The top lid is not closed
The top lid is not closed
Is the drain hose blocked by
foreign material?
Is there metal material inside
the washing machine?
Are the laundries slanting in
spinning?
Is the machine slanting?
Is there power failure?
Is the water faucet open or is
there water supply failure?
Is the power plug loose?
Is the water inlet valve is
blocked
Is the jointer of the water inlet
hose is loose or twisted awry?
Close the top lid
Close the top lid
Use it when the power is on.
Level the machine properly.
Fasten the jointer properly.
Insert the power plug tightly.
Fasten the buttons and zipper
Re-order the laundries. Close the
top lid.
Clean the foreign material. Open
and close the top lid once.
Phenomena The reason How to settle
No water filling
If plug is inserted firmly?
If tap is turned on?
If Power On/Off and
Start/Pause is pressed?
Insert the plug firmly
Turn on the tap
Press Power On/Off and
Start/Pause
Open the water faucet. Open
and close the top lid once.
Clean the water inlet valve.Open
and close the top lid once.
The numeral tube shows
F2
Please contact the after-sales
service department.
Overflow alarm