Filter
Top Products
Install the bottom plate
4
Please install and adjust the machine according to the directions contained
in this manual. It is very important to follow these directions for the safe
operation of the machine, and to ensure your machine operates correctly.
Installation & Adjustment
Balance washing machine
After removing washer from outer packaging, take
out the lint filter from the document bag, install it to
the inner tub. See the figure opposite
Install the lint filter
Inner tub
Lint filter
Please ensure the lint filter is installed correctly and
maintained in good condition to ensure the water outlet is
not blocked or the flow altered. If the lint filter is lost or
damaged, contact Customer Care.
The purpose of the bottom plate is to suppress noise
from the washing machine during operation.
Steps:
1. Lay the washer on its back, on a non-abrasive
surface.
2. Place the plate on to the bottom of the machine.
3. Use a screwdriver to tighten the screws ( in
accessory bag) securing the panel to bottom of
the washer.
4. Once all screws are tight and the panel is
secure, return the washer to its standing
position.
Screw
Two fasteners
Bottom plate
Cparpet
Front
Back
Down
Dismantle
Install
Up
Model HWMP55-918
Model HWMP65-918
Do not install this machine on an incline greater than 2° . Installing machine on an
angle or on rough ground will result in unstable running or stoppage of the
machine. Please adjust it by the following method:
1.Confirm it is level£»
2.Lift up the side of the leg slightly and twist the adjustable leg.
Note:The distance between the washing machine
and wall:at least 20 mm.
20mm
20mm
High
Low