Filter
Top Products
12
3
Wash
Rinse
Spin
For the "Synthetic"and "Memory" cycles the machine will run a Fuzzy Logic program
that automatically detects the type of laundry in the tub. After detection
it will set the water level automatically.
The water level can only be changed once the machine has started by pushing the
"Start/Pause" button, then push the "Water Level" button to reset the water level.
Press the "Start/Pause" button to resume the wash cycle
4
Water
Level
Water
Level
Press the button to change the water level
5
Temp
Wash/Rinse
Press the button to select the the wash and rinse temperature
Press the buttons to customise the pre-set options
To set a delay time, first select the Cycle and options required and push the
Delay" button
The cycle indicator lights will go off and the "Delay (Hours) indicator light will be on.
During the delay program, press the "Delay" button to display the time remaining.
The delay time indicator shows the time remaining till the wash ends.
To cancel the delay program, switch the power off and back on, then make a new
selection.
Delay start (2-24hr) option
Delay time is to the end of washing washing cycle
6
Delay
Press the button to select the delay wash program
The delay time program is automatically off, and wash cycles will start as soon as
Start/Pause button is pushed.
The wash will finish
in about 18 hours
During Rinse cycle, only SPIN times can be set, all other wash functions are locked.
During Wool and Tub Dry cycles, these settings cannot be changed and buttons will
not function, as machine will only follow pre-programmed settings.
Set the wash and rinse temperatures in accordance to the requirements of each
load. The wash and rinse temperatures will be the same (i.e. if Warm/Cold
is selected, both wash and rinse cycles will be warm/cold).
Even there is no water in the tub a certain period is required before spinning
Separate colour fast clothes before loading washing machine.
Operation & Wash Cycles