Filter
Top Products
S
TA
R
T
PA
U
S
E
S
EL
F
-P
RO
G
R
A
M
Installation and adjustment
4 Push the " WATER LEVEL button, select suitable water level"
After switching on the power and the standard normal washing machine will execute fuzzy
program automatically to detect the cloth.After defection, it can set the water level automatically. To select other
water level, first push the "start/pause" button, then push the "water level" button to
set the water level.
" "or" "programs set,
5 Push the button and + button
to select suitable program
"SELF-PROGRAM" " " " -"
6 Push the "START/PAUSE" button
7 Finish washing
As the top lid opened, the washer will automatically given alarm and stop running,
exclusively during draining
The soak procedure can work in cooperation with automatic programs like standard,normal, jeans, and fiber .
There is intermittent pulsator stirring during soak.
After the machine starts operation, you can only set the program and procedure during washing,soak and can not
make setting in other cases.
Attention
.
Even there's no water in the tub, a certain period is
required before spin starting.
Do not use the soak program for the woolen textiles.
Separate the laundries that are not colorfast from
other laundries in washing.
The pulsator will not rotate unless the water is
filled to"18L"water level.
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Install the bottom plate
The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground
will result in unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
Fasten
Loosen
the adjustable nut
the adjustable feet
High
Low
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
2 . After adjustment, fasten the nut.
Adjust the Installation position
After opening the package, please lean the
washing machine gently down on soft items
(like towel cloth,blanket, etc.). Install the bottom
plate to the bottom of the machine with one
screw by a cross screwdriver, then lift the machine
up gently. See to the figure:
I
I enlarge
Carpet
Front
Back
The two claws of bottom plate should
insert the two strip holes ,and insure
WATER
LEVEL
Set up time Of soaking, washing, dehydration and times of rinse you can also set up an
appointment; set that means chosen the appointment booking functions, after start,
the light of process you choose will be off, a digital displays the remaining appointment
time (hours). Appointment process, holding down the "self-programming" button to display
the status of an appointment that shows the procedure of your choice, water, process and
the remaining time (minutes). Run the program to change or cancel an appointment,
need to cut off the power supply, re-select. In the light of article 11 can be "self-programming"
button and select button "+""-".
After the laundry process, washing machines beep alarm, and then automatically power off
3 Push the button"PROCESS"
You can choose one or more process among soak, wash, rinse, spin.
The button is invaid if you choose QUICK or TUB DRY program.
You can not choose soak process if you choose WOOL program.