Filter
Top Products
Software Mode
Select one of the following event modes: Motion Detection, Video Loss, and Boot.
Motion Detection: Event occurs when the motion is detected.
Video Loss: Event occurs when there is loss of video (disconnected or connected).
BOOT: Event occurs when the Camera Server is rebooted.
MD
Enable only if software mode is set to Motion Detection.
To set the MD value, press the View CGI button on the Motion setting page to see the MD values.
34
For example, if MD is set to “M0,” it means motion detection is triggered from Layer1. In the same
manner, M1 means Layer 2 and M2 means Layer 3.
Video Loss
Enter camera number for triggering the event.
Image Number
Enter camera number to connect with event
Trigger Interval
1 second (’00:00:01’) is set as the default value. Assuming the value is ’00:00:05,’ even if the event
happens several times for 5 sec, the Camera Server will trigger only once per 5 seconds.