Filter
Top Products
Grandstream Networks, Inc. HT503 User Manual Page 23 of 38
Firmware 1.0.4.2 Last Updated: 06/2011
V
ia HTTPS
The URL of the HTTP server used for firmware upgrade and configuration via a secure HTTP
connection.
For example, https://provisioning.mycompany.com
Note: the HTTPS default port is 443.
Firmware Server
Path
IP address or domain name of firmware server.
Config Server Path
IP address or domain name of configuration server.
XML Config File
Password
The password used for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration file.
HTTP/HTTPS User
Name
The user name for the HTTP/HTTPS server.
HTTP/HTTPS
Password
The password for the HTTP/HTTPS server.
Firmware File
Prefix
Default is blank. If configured, HT503 will request the firmware file with the prefix. This
setting is useful for ITSPs. End user should keep it blank.
Firmware File
Postfix
Default is blank. End users should keep it blank.
Config File Prefix Default is blank. End users should keep it blank.
Config File Postfix Default is blank. End users should keep it blank.
Automatic Upgrade
Choose “Yes” to enable automatic upgrade and provisioning. When set to No, HT503 will
only do upgrade once at boot up.
When “Check every day” or “Check every week” is checked, user can specify “Hour of the
day(0-23)” or “Day of the week(0-6)”. Default time is Monday 1AM.
There are three options to choose from: “Always check for New Firmware at Boot up”, “Check
New Firmware only when F/W pre/suffix changes”, and “Always Skip the Firmware Check”.
Authenticate Conf
File
This protects the configuration from an unauthorized change. If set to “Yes, the configuration
file is authenticated before acceptance.
Firmware Key
Key for firmware encryption. (32 digits in hexadecimal format. End users should keep it blank.
SSL Certificate
The user specified SSL certificate used for SIP over TLS in X.509 format.
SSL Private Key
The user specified SSL private key used for SIP over TLS in X.509 format.
SSL Private Key
Password
User specified password to protect the private key above.
ACS URL
User specify the Auto Configuration Server’s URL (TR-069 protocol)
ACS Username
User specify the ACS Username
ACS Password
User specify the ACS password
Periodic Inform
Enable
Default is No. If set to YES, device will send inform packets to the ACS
Periodic Inform
Interval
Frequency that the inform packets will be sent out to the ACS
Connection
Request Username
Set a user name for the ACS to connect to this device
Connection
Request Password
Set a password for the ACS to connect to this device
System Ring
Cadence
Configuration option for FXS port ring cadence for all incoming calls. (Syntax: c=on1/off1-
on2/off2-on3/off3; [...])
Call Progress
Tones
Using these settings, users can configure tone frequencies according to their preference. By
default they are set to North American frequencies.
These tones should be configured with known values to avoid uncomfortable high pitch
sounds. ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In
order to set a continuous tone, OFF should be zero. Otherwise it will ring ON ms and a pause
of OFF ms and then repeat the pattern.
Example for North America Dial Plan:
f1=350@-13,f2=440@-13,c=0/0;
Syntax: f1=freq@vol, f2=freq@vol, c=on1/off1-on2/off2-on3/off3; [...]