Filter
Top Products
Consumer Support
Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation
Instructions
About the washer features.
NOTE: Features may not be available on all washer models.
Cycle Signal
Use the SIGNAL button to change
the volume of the end of cycle signal.
Press the button until you reach
the desired volume.
Prewash (on some models)
Prewash is an extra wash before
the main wash. Use it for heavily soiled
clothes or for clothes with a care label
that recommends prewashing before
washing. Be sure to add high-efficiency
detergent, or the proper wash additive
to the prewash dispenser.
NOTE: When selecting prewash,
it is recommended to use powder
detergent in the main wash (detergent)
compartment.
Extra Rinse
Use an extra rinse when additional rinsing
is desired to remove excess dirt and
detergent from soiled loads.
Delay Start
You can delay the start of a wash cycle
for 10–18 hours, depending on the model.
Press the DELAY START button to choose
the number of hours you want to delay
the start of the cycle, then press the START
button. The machine will count down and
start automatically at the correct time.
NOTE: If you forget to fully close the door,
a reminder signal will beep reminding you
to do so.
NOTE: If you open the door when the delay
is counting down, the machine will enter
the pause state. You must close the door
and press START again in order to restart
the countdown.
Lock
You can lock the controls to prevent any
selections from being made. Or you can
lock the controls after you have started
a cycle.
Children cannot accidentally start
the washer by touching pads with
this option selected.
To lock the washer, press and hold
the DELAY START button for 3 seconds.
To unlock the washer controls, press
and hold the DELAY START button for
3 seconds.
The control lock icon on the display will
light up when it is on.
NOTE: The POWER button can still be
used when the machine is locked.
HOLD 3 SEC
TO
STORE
M
Y
C
YCLE
MY CYCLE (on some models)
To save a favorite cycle, set the desired
settings for wash cycle, soil level, spin speed
and wash temp settings and hold down the
MY CYCLE button for 3 seconds. A beep will
sound to indicate the cycle has been saved.
To use your custom cycle, press the
MY CYCLE button before washing a load.
To change the saved cycle, set the desired
settings and hold down the MY CYCLE
button for 3 seconds.
NOTE: When using MY CYCLE, wash
options cannot be modified after the
cycle has been started.
NOTE: If you change wash options with
MY CYCLE before starting the cycle, the
MY CYCLE light will turn off and you will
be returned to the base cycle.
8
7
8
9
10
11
12
BASKET CLEAN
BasketClean is a cycle that freshens up
the inside of your washer. The cycle uses
bleach or other available washing
machine cleaners and more water to
refresh your washer. Use BasketClean
once every month to reduce odor and
residue buildup inside the washer.
For more information on BasketClean,
refer to the Care and Cleaning section
on page 11.
13