Filter
Top Products
20
UNPACKING THE WASHER
1. After removing the washer from its carton, remove all base
packaging, including the cardboard, styrofoam base and
styrofoam tub support (inserted in center of base). Save
the stacking brackets located on the styrofoam pad that
covered the top of the washer.
NOTE: If you are installing a pedestal, proceed to
the installation instructions that come with the pedestal.
2. Carefully move the washer to within 4 feet (122 cm)
of the final location.
3. Remove the following from the back side of the washer:
4 bolts
4 plastic spacers (including rubber grommets)
4 power cord retainers
4. Remove the shipping bolt. Insert plug into shipping
bolt hole.
NOTE: Failure to remove the shipping braces can cause
the washer to become severely unbalanced.
Save all bolts for future use.
NOTE: If you must transport the washer at a later date,
you must reinstall the shipping support hardware to prevent
shipping damage. Keep the hardware in the plastic bag
provided.
Installation Instructions