Filter
Top Products
Installation Instructions
I_ DRYER EXHAUST TO LEFT OR
BOTTOM CABINET
WARNING- BEFORE PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS FROM SHARP EDGES
WHEN WORKING INSIDE THE CABINET.
BE SURE TO WEAR GLOVES
REMOVE
SCREW
ANDSAVE.
O_ REMOVE
DESIRED
KNOCKOUT
(ONEONLY).
Detach and remove the bottom or left side knockout as
desired. Remove the screw inside the dwer exhaust duct
and save. Pull the duct out of the duet.
FIXINGHOLE
B A
9"
Cut the duct as shown and kee I) portion A.
TAB LOCATION
BENDTAB
UP450
Through the real" opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45° using a fiat
blade screwdriver.
7
ADDING NEW DUCT
FIXING
HOLE
PORTION"A"
LEFTSIDE
EXHAUST
Reconnect dm cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT SIDE OF CABINET
• Preassemble 4" elbow with 4" duct. Wrap duct tape
around joint.
• Insert duct assembly, elbow first, through the side opening
and connect the elbow to the dwer internal duct.
CAUTION: Be sure not to pull or damage the
electrical wires inside the dryer
when inserting the duct,
J_
DUCT
// TAPE
• Apply duct tape as shown on the joint between the diTer
internal duct and the elbow.
DUCT
TAPE
CAUTION:
Internal duct joints must be
__ secured with tape, otherwise
they may separate and cause
a safety hazard.