Filter
Top Products
4
Installation instructions
Remove the packaging
Remove the packaging reinforcement underneath the product by tilting the machine and pulling
the extruding ribbon. Not doing so may cause damage to your floor during normal operation of
the machine.
Removing the transit safety bolts
The clothes washer is fitted with transit safety bolts at the rear to avoid any possible damage to
the interior during transportation.
Important!
The transit bolts MUST be removed prior to operation of the machine. Failure to remove these will
result in damage to the machine.
To remove the bolts:
1
Loosen all the bolts with a spanner until they rotate freely (“C”).
2
Remove the transit bolts by turning them gently.
3
Fit the bolthole covers (supplied in the bag with the operation manual) into the holes on the
rear panel (“P”).
Fig.1 Removing the transit safety bolts
Please keep these transit safety bolts in a safe place to reuse before transporting the machine in
the future.
Never transport the machine without the transportation safety bolts properly fixed in place.
Positioning the machine
Move the machine into position without lifting by the top panel.
Install the machine on a solid and level floor surface, preferably in a corner of the room.