Fisher & Paykel GWLO8 Washer User Manual


 
32
MANUAL SUDS SAVE WITH SIPHON BACK
If you have a large tub near your washing machine
and a separate drain outlet you can set up another
method of reusing the water.
(The tub should hold a minimum of 27 gallons (100
litres) or have an overflow.)
1. Select SOAK on the first wash cycle.
2. At the end of the wash phase place the drain hose
in the tub.
3. Cancel SOAK (press ADVANCE button). The suds
water will be pumped into the tub. Do not leave
your machine until pump out is completed.
4. ONCE YOUR TUB IS FILLED RETURN THE
DRAIN HOSE TO THE DRAIN. THIS MUST BE
DONE BEFORE THE MACHINE STARTS
SPINNING.
5. Allow the machine to complete the rest of the
cycle. Remove the first wash load and place the
second load in the machine.
6. To siphon back the suds place the end of the
drain hose in the tub, ensure that the end is near
the bottom of the tub.
7. Advance to SPIN and allow the machine to pump
for a few seconds to clear air from the drain hose,
then press POWER to turn the machine off.
8. The suds water will siphon back into the machine.
It will take several minutes to siphon back the
water.
9. RETURN HOSE TO DRAIN.
10.Select second wash cycle.
The above method can also be used to recycle the
water from a deep rinse. Select SPIN HOLD in place
of SOAK.
Note: For any of the above methods, manually
select the water level for the second wash load.
Auto water level may fill to a level too high for the
clothes load if there is already water in the washing
machine.
Note: You will only be able to
siphon back into the machine
until the water level is equal to
that in the tub.
1133 LDY Use & Care (USA) 16/5/01 3:34 PM Page 34