Filter
Top Products
CHANGING PRE-SET OPTIONS
OPTION ADJUSTMENT MODE
After using your Smart Drive you may want to
change some of the pre-set options to suit your
wash needs.
You can change the following pre-set options:
• the rinse option on Heavy Duty, Regular and
Wool cycles
• the amount of water used in the Water Saver
option
• the number of beeps at the end of the cycle
• the Out of Balance recovery routine
• the fill level selected by auto water level
To make these changes it is necessary to enter
the “Option Adjustment Mode”.
TO ENTER OPTION ADJUSTMENT MODE
1. Plug the machine in, but do not press POWER.
Press START / PAUSE and hold down.
Press POWER.
2. When the buttons have been pressed correctly the
machine will give two quick beeps and show an
unusual pattern of lights.
In this mode the lights are used to indicate the
different options available. The diagram on page
24 shows how the lights relate to the options you
can change.
Pages 25 - 27 explain the different options in
more detail.
3. Use the buttons on the panel to make your
changes to the pre-set options.
4. Press POWER to return to normal mode.
5. Your Smart Drive will automatically remember
your changes.
6. To make further changes, repeat the above steps.
CHANGING PRE-SET OPTIONS
23
1133 LDY Use & Care (USA) 16/5/01 3:34 PM Page 25