Filter
Top Products
53
Settings Menu
After using your AeroSmart dryer you may wish to fine-tune some of the options to suit your
individual needs. Any options changed in this menu are a permanent change, unless ‘Reset
Defaults’ is selected (refer to page 55).
To access the Settings Menu:
1
Turn your AeroSmart dryer on.
2
Scroll, to the right, through the drying cycles until you reach the Settings Menu.
3
Press SELECT to enter the menu.
Alarm Beeps
The number of beeps that signal the end of the cycle can be altered. Choose
between no beeps, five or fifteen beeps.
Screen Brightness
You can adjust the brightness of your screen to suit your individual needs.
Key Lock mode
Key lock automatically locks the buttons on your AeroSmart when not in use. This
will avoid accidental button pushes from items left on the lid of the dryer and also
from any little fingers.
To turn Key Lock Mode ON or OFF:
Access the Settings Menu (refer above).
Scroll to the KEY LOCK MODE option, and press SELECT.
Use the SCROLL buttons to select ON or OFF.
Press SELECT to confirm your selection and return to the Settings Menu.
If Key Lock mode is switched ON:
To turn your dryer on, push and hold the POWER button for 3 seconds. This will
activate the display panel. You will then be able to select your drying option and
press START. The buttons will then be locked.
To PAUSE your dryer at any time during the cycle, press the PAUSE button twice.
This will allow you access to the Cycle Options, then press START to restart your
cycle. The buttons will then lock.
To STOP your dryer and power off, press the POWER button twice.
If you can’t remember how to unlock the buttons, press any button and the display
screen will remind you.
EN