Filter
Top Products
Removing transport safety equipment
Caution! Before first starting up,
all parts of the transport safety
equipment must be removed.
1.Open loading door
2. Pull off adhesive strips from inside
machine on top of drum.
3. Remove foil hose and polystyrene
padding from the machine.
Electrical connection
Any electrical work required to install this appliance should be carried out by a
qualified electrician or competent person.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure not be
observed.
Should the appliance power supply cable need to be replaced, this must be
carried out by our Service Centre.
Before switching on, make sure the electricity supply voltage is the same as that
indicated on the appliance’s rating plate. (See picture on page 8).
The appliance is supplied with a 13amp plug fitted.
In the event of having to change the fuse in the plug supplied, a 13amp ASTA
approved BS 1363/A fuse must be used.
The power supply cable must be accessible after installing the machine.
27
125983990.qxp 2006-04-21 07:12 Page 27