Filter
Top Products
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The special
bulb is available from the local Service Force Centre.
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly behind
the loading aperture, at the top; refer to “Description of machine” section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be operated.
Problem Possible cause Remedy
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete“).
Lint filter clogged. Clean lint filter.
Heat exchanger clogged
with lint.
Clean heat exchanger.
SPECIAL CARE
button pressed and load
volume too big.
SPECIAL CARE is only suita-
ble for use with
loads of up to 3,5 kg!
Load volume too big. Reduce load volume.
Laundry insufficiently pre-
drained.
Laundry must be adequately
pre-drained.
Drying cycle ends
shortly after programme
starts. END display illumina-
ted.
Not enough washing loaded
or washing loaded is too
dry for selected programme.
Select time programme or
higher drying level (e.g.
INTENSIVE DRY instead of
STORAGE DRY).
23
125983990.qxp 2006-04-21 07:12 Page 23