Filter
Top Products
Clean the entire filter area
The strainer area does not have to be cleaned after every drying cycle,
but should be checked regularly and cleaned of fluff if necessary.
6. To do this, grip the top of the large
mesh filter and pull it forwards
until it comes loose from the two
brackets.
7. Remove fluff from the entire filter
area. It is best to use a vacuum
cleaner for this purpose.
8. Press both journals of the large
mesh filter into the brackets on the
loading door until they snap into
place.
9. Re-insert fine strainer.
10. Press against the large mesh filter
until it locks into the interlock.
If the fine strainer is not fitted,
the large mesh filter will not snap
into place and the loading door
cannot be closed.
Cleaning the door seal
Wipe the door seal with a damp cloth immediately after the drying cycle
has finished.
18
125983990.qxp 2006-04-21 07:12 Page 18