Filter
Top Products
Conductance of water at in-
stallation site differs from
standard setting of machine.
Re-programme standard set-
ting for degree of drying (see
‘Programming options’ chap-
ter).
Loading door does not close. Filter not in place. Install filter into place.
When a button is pressed,
Err
appears on the LCD.
Washing protection. After the
start of the programme, the
option can no longer be set.
Turn the programme knob to
UIT (off). Set the programme
again.
Drum light does not work.
Programme selector in UIT (off)
position.
Turn programme selector to
LICHT AAN (light) or to any pro-
gramme.
Defective light bulb.
Replace light bulb (see next
section).
Displayed programme time
changes erratically or stays un-
changed for a long time.
Programme time is corrected
automatically depending on
type and volume of laundry
and level of dampness.
Automatic process; this is not a
machine fault.
Drying cycle ends shortly after
programme starts.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Select time programme or
higher drying level (e.g. EXTRA
DROOG (extra dry) instead of
KASTDROOG (stroage dry)).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically.
Filter clogged. Clean filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
Particularly high room temper-
ature. Temporary switching off
of the compressor to avoid
overload.
Automatic process, there is no
fault with the appliance. If pos-
sible, lower the room tempera-
ture.
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be
obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 minutes
when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the machine!
Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,
at the top; refer to “Description of machine” section.)
2. Replace defective bulb.
3. Screw cover back down.
What to do if ...
45